HID Fargo DTC1250 - Page 43

October 2013 Page 43
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
DTC1250e/DTC1000Me/DTC4250e Card Printer User Guide, PLT-01668, 1.0
Setting
Description
OLED Contrast
(display contrast)
Use this option to increase or decrease the contrast of the printer
OLED (if applicable).
Ribbon Calibrate Blue
This setting is a calibration driven value and should not be
adjusted.
It is factory set and should not be changed unless directed by a
technician.
Cleaning Rate
Use this option to adjust the number of cards printed before the
Printer displays a message indicating cleaning is needed.
• The default value is 3000 cards.
Mag HI-Co Voltage Offset
This setting is a calibration driven value and should not be
adjusted.
It is factory set and should not be changed unless directed by a
technician.
Mag Lo-Co Voltage Offset
This setting is a calibration driven value and should not be
adjusted.
It is factory set and should not be changed unless directed by a
technician.
Ribbon Green LED Level
This setting is a calibration driven value and should not be
adjusted.
It is factory set and should not be changed unless directed by a
technician.
Ribbon Blue LED Level
This setting is a calibration driven value and should not be
adjusted.
It is factory set and should not be changed unless directed by a
technician.
Erase Heat Offset
Adjust the Erase temperature for the rewriteable cards as needed.
Increase the Current Setting to cause more heat to be used in the
erasing process.
OR
Decrease the Current Setting to cause less heat to be used in the
erasing process.
Note: Erase Heat Offset provides user ability to control the
Printhead heat level when the Erase Operation is performed.
Appropriate heat levels should be applied for the proper erase
process. This setting should be adjusted for proper erasure.
Write Heat Offset
Adjust the Write temperature for the rewriteable cards as needed.
Increase the Current Setting to cause more heat to be used in the
printing process of a rewritable card.
OR
Decrease the Current Setting to cause less heat to be used in the
printing process of a rewritable card.
Note: Write Heat Offset provides user capability to control the
printhead heat level when the Write Operation is performed.
Appropriate heat levels should be applied for the proper writing
process.