Page 42 October 2013
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
DTC1250e/DTC1000Me/DTC4250e Card Printer User Guide, PLT-01668, 1.0
Example:
Setting Description
Head Resistance
This is factory set. If the main board or the Printhead is replaced
then adjust this number.
Locate the Printhead Setting Number on the bottom of the
Printhead.
Print Left of Form
Use this option to adjust the vertical position of the printed image
on the card; so it appears centered.
• Maximum Adjustment Range is +/- 127.
• Each increment equals .01”.
Image Darkness
Use this option to set the overall darkness of the printed image by
increasing or decreasing the amount of heat (used by the
Printhead when printing).
Caution: If the value is set too high, the Ribbon may
Print Top of Form
Use this option to adjust the length-wise or horizontal position of
the printed image on the card (so it appears to be centered).
Caution: If the negative value is set too high, the Print
Mag Top of Form
Use this option to shift the starting point where the Printer begins to
encode the magnetic track data on the card’s Magnetic Stripe.
Caution: If the negative value is set too high, the
Printer may start encoding before the Magnetic Stripe reaches the
encoding head.
• Maximum adjustment range is +/- 80.
• Each increment equals .01”.
Ribbon Print Tension
Use the Ribbon Tension option to increase or decreases the
amount of tension (drag) on the Ribbon during printing.
Ribbon Calibrate Green
This is a calibration driven value and should not be adjusted.
Note: This is factory set and should not be changed unless
directed by a technician.
Resin Heat Adjust
Use this adjustment for Black premium resin text and barcodes if
they appear faded, too light or too dark.
Maximum Adjustment Range is +/- 100.
Note: This control can be helpful for fine-tuning the transfer of
resin text and bar codes.
Sleep Time
The Sleep Time setting adjusts the number of minutes of inactivity
before the Printer enters a low power sleep state.
To Next Page
Loading...
