HID Fargo HDP8500 - Page 178

© 2012 HID Global Corporation. All rights reserved.
178
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
Ribbon together and wind any
excess onto the Take-up Spool.
Re-install the Print Ribbon, close
the Printer‟s Cover and press
the Resume button on the
Printer to continue printing.
c. To cancel the print, press the
Cancel Print button on the
Driver‟s display dialog or the
Cancel button on the printer.
Ribbon Sensor Error
The Printer cannot find
the next panel on the Print
Ribbon.
Recalibrate the Ribbon Sensor
using the Calibrate Ribbon Tab
within the Toolbox.
To cancel the print, press the
Cancel Print button from the
Driver's display dialog and the
Cancel button on the Printer's LCD
display.
Invalid Ribbon
An incorrect Print Ribbon
has been installed in the
Printer.
Check that the ribbon is correct for
the printer and retry.
To cancel, click on Cancel Print.
Ribbon Error
The Print Ribbon caused
a general error.
Press the Resume button located
on the Printer to continue.
To cancel, press the Cancel Print
button or the Cancel button located
on the Printer.
No Magnetic
Encoder Installed
A print job with Magnetic
encoding was sent with no
Magnetic Encoder
installed in the printer.
Ensure that no encoding data is
being sent with the print job and
reprint the card.
Mag Verify Error
The printer is unable to
verify encoded data.
Check the Cards and click on
Cancel Print.
No Mag Strip
Present
The Printer is unable to
find a Magnetic stripe on
the card.
Check the Cards and click on
Cancel Print.
No Smart Card
Encoder
No Smart Card Encoder is
installed in the printer.
To cancel, click on Cancel Print.