HID Fargo HDP8500 - Using the Lamination Card Backup Option; Using the Lamination Card Length Option; Using the Lamination Fan Speed Option; Using the Lamination Peel off Delay Option

© 2012 HID Global Corporation. All rights reserved.
139
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
Using the Lamination Card Backup Option
This option changes distance card backs up after lam pressure is first applied
Using the Lamination Card Length Option
This option dictates length of card (should not be adjusted)
Using the Lamination Fan Speed Option
This option adjust the fan speed level 0 - 100%, 1 - 75%, 2 - 50%, 3 - 25% (replicate printer fan
speed control)
Using the Lamination Peel Off Delay Option
This option adjust the delay between lamination stage and peel off stage.
Reviewing the No Printer Connected error message
If there is no Printer connected or if the Driver is unable to communicate with the Printer, the
following error will be displayed and the grid will be blank.