Thermal Image Scope User Manual
18
reticle more accurately.
Steps
1. In the main menu, press or to select and press to enter zeroing interface.
2. Select a zeroing No. You can set 5 reticles.
a) Press or to select , and press to confirm.
b) Press or to select a zeroing No. to correct.
c) Press again to confirm.
3. Set distance to target.
a) Press or to select , and press to confirm.
b) Press to switch the digit.
c) Press or to change the number, and press again to confirm.
4. Aim the target, trigger an activation, and start the zeroing.
a) Press or to select , press to freeze the image.
b) Select , and press or to enlarge the image until the target positions is clear
enough.
c) Select the or , and press to confirm. If you select , the reticle moves
left and right; if you select , the reticle moves up and down.
d) Press or to aim the big reticle at the point of impact.
e) Hold to save the settings according to the prompt.
Figure 4-2 Enable Freeze
To Next Page
Loading...
