Thermal Image Scope User Manual
17
Chapter 4 Zeroing
4.1 Select Zeroing Profile
If different users use the same device, the users can configure and save the reticle settings in their
respective zeroing profiles.
Steps
1. In the live view mode, hold to show the main menu.
2. Select , and press to confirm.
3. Press or to select a zeroing profile.
4. Hold to save and exit.
Result
The right top of the image displays the reticle information. For example, C1-100m means you are
using the No. 1 reticle in zeroing profile C, and the set distance is 100 m.
Figure 4-1 Select a Zeroing Profile
Note
There are 5 zeroing profiles in total, and you can configure 5 reticles in each zeroing profile.
4.2 Correct Reticle
Correcting the reticle can help you aim at the target with high accuracy by marking the offset
between the big reticle and small reticle. Functions such as Freeze and Zoom help to adjust the
To Next Page
Loading...
Need help?
General
