Thermal Image Scope User Manual
23
Figure 6-1 Brand Logo Display
Note
After enabling this function, the brand logo only displays on the live view interface, captures and
videos.
6.3 Set Display Brightness
You can adjust the display brightness of the screen.
Steps
1. In the live view mode, press to show the quick menu.
2. Select , and press to confirm.
3. Press and to adjust display brightness.
4. Hold to save settings and exit.
6.4 Burning Prevention
This function can prevent the detector of the thermal channel from being burned. When you
enable this function, the shield will close if the grey scale of the detector reaches a certain value.
Avoid direct sunlight and enable the Burning Prevention function to reduce the risk of sensor
damage from the heat.
Steps
1. Hold to show the main menu.
2. Go to Function Settings, and select .
3. Press to enable or disable the burn-prevention function.
4. Hold to save settings and exit.
6.5 Capture and Video
6.5.1 Capture Picture
In the live view mode, press to capture picture.
Note
When capturing succeeds, the image freezes for 1 second and a prompt shows on the display.
For exporting captured pictures, refer to
Export Files.
To Next Page
Loading...
Need help?
General
