Thermal Image Scope User Manual
21
Chapter 5 Measure Distance
The device can detect the distance between the target and the observation position.
Before You Start
When measuring the distance, keep the hand and the position steady. Otherwise, the accuracy
may be affected.
Steps
1. Hold to show the main menu.
2. Press or to select , and press to enter the measurement interface.
1) Press to show the setting interface. Press or to select the target from Deer,
Grey Wolf, Brown Bear, and Custom, and press to confirm.
2) Press or to change the number, and set the target height.
Note
The available height ranges from 0.1 m to 9.0 m.
3) Hold to save the setting and return to the measurement interface.
3. Align the center of top mark with the edge of target top. Press .
The cursor blinks on the top edge of the target.
4. Align the center of bottom mark with the edge of target bottom. Press .
Result
The right top of the image displays the distance measurement result and the height of the target.
Figure 5-1 Measurement Result
To Next Page
Loading...
