HikRobot X86 - Chapter 2 Device Installation; 2.1 Required Accessories; 2.2 Lens Installation and Replacement

X86 Open Platform·User Manual
7
Chapter 2 Device Installation
2.1 Accessory
You need to prepare following accessories before installation.
Table 2-1 Recommended Accessories
No.
Name
Quantity
Description
1
Power and I/O cable
× 1
It refers to the 12-pin power and I/O cable.
2
Network cable
× 1
It refers to the RJ45 network cable with
aviation connector.
3
Interface expansion
cable
× 1
It refers to the interface expansion cable.
4
Interface expansion
module
× 1
It refers to the interface expansion module.
5
DC switching power
supply
× 1
Power adapter above 12 VDC, 2 A or 24
VDC, 1 A.
6
Lens
× 1
It refers to C-mount lens.
7
Mounting bracket
× 1
It is used to fix the device.
8
Waterproof lens cover
× 1
It is used to protect lens and light source.
2.2 Install and Change Lens
Follow steps below to install or change lens.
Steps:
1. Screw out the waterproof lens cover, and take out the lamp cup.
2. Install the required C-mount lens to the device, or change the lens.
3. Reinstall the lamp cup and the lens cover again.