HikRobot X86 - Chapter 5 Image Acquisition; 5.1 Setting Acquisition Frame Rate; 5.2 Trigger Mode Configuration

X86 Open Platform·User Manual
19
Chapter 5 Image Acquisition
5.1 Set Frame Rate
You can set frame rate as shown below.
Steps:
1. Click Image Setting > Acquisition Frame Rate.
2. Enter frame rate according to actual demands.
Figure 5-1 Set Frame Rate
The Resulting Frame Rate displays the device’s real-time frame rate.
5.2 Set Trigger Mode
The device has 2 types of trigger mode, including internal trigger mode and external trigger mode.
The trigger mode principle and parameter setting are shown below.
Table 5-1 Trigger Mode Principle and Parameter
Trigger Mode
Parameter
Parameter Value
Principle
Internal
trigger mode
Trigger and IO
Control > Trigger
Mode
Off
The camera acquires images via its
internal signals.
External
trigger mode
Trigger and IO
Control > Trigger
Mode
On
The camera acquires images via
external signals. These signals can
be software signal and hardware
signal, including software trigger,
hardware trigger, and counter
trigger.