X86 Open Platform·User Manual
10
2.4 Wiring
Follow steps below to wire the device.
Steps:
1. Use 8-pin RJ45 network cable with aviation connector to connect the device to a switch or a
network interface card (NIC).
Figure 2-6 Connect Network Cable
2. Use 12-pin power and I/O cable to connect the device to a proper power adapter or switching
power supply.
Figure 2-7 Connect Power and I/O Cable
3. If expansion interface is required, connect corresponding cable, as shown below.
Figure 2-8 Connect Expansion Interface Cable
To Next Page
Loading...
