HikRobot X86 - Image Adjustment Parameters; 8.5 Gain Configuration

X86 Open Platform·User Manual
35
8.5 Set Gain
The X86 open platform supports gain function. For specific gain range that the device supports,
please refer to the specifications of the device.
The device has 3 types of gain: Off, Once and Continuous. The gain mode and principle are shown
below.
Table 8-2 Gain Mode and Principle
Gain Mode
Parameter
Parameter Value
Principle
Off
Image Setting > Gain
Auto
Off
The device adjusts gain
according to the value
configured by user in
Gain(dB).
Once
Image Setting > Gain
Auto
Once
The device adjusts the gain
automatically according to
the image brightness. After
adjustment, it will switch to
Off Mode.
Continuous
Image Setting > Gain
Auto
Continuous
The device adjusts the gain
continuously according to
the image brightness.
You can set gain as shown below.
Steps:
1. Click Image Setting > Gain Auto.
2. Set Gain Auto according to actual demands.
Figure 8-6 Set Gain Mode
When Gain Auto is Off, you can set gain value by enter proper value in Gain(dB).