HikRobot X86 - Firmware Updates and Communication; 9.4 Indicator Status Explanation

X86 Open Platform·User Manual
45
 Save Parameters
Steps:
1. Click User Set Control, and select a user set in User Set Selector. Here we take selecting User
Set 1 as an example.
2. Click Execute in User Set Save to save parameters.
Figure 9-5 Save and load User Set
 Load Parameters
Steps:
1. Click User Set Control, and select a user set in User Set Selector. Here we take selecting User
Set 1 as an example.
2. Click Execute in User Set Load to load parameters to the device.
 Set User Default
You can also set default parameter by selecting parameter from drop-down list of User Set Default.
 Save the custom parameters setting and select it as the default one, otherwise the device
adopts the default set every time after it being rebooted.
 0 stands for the default factory set, 1 stands for the user set 1, 2 stands for the user set 2, and
3 stands for the user set 3.Set Indicator
9.4 Set Indicator
The device has 2 indicators, including User1 LED, and User2 LED. You can view these indicators to
check the device’s operation status, as shown below.