HikRobot X86 - 8.10 White Balance Configuration

X86 Open Platform·User Manual
40
8.10 Set White Balance
White balance is only available for color device.
The white balance refers to the color adjustment depending on different light sources. Adjust the
gain value of the image’s R channel and B channel to keep white regions white under different
color temperatures. Ideally, the proportion of R channel, G channel and B channel in the white
region is 1:1:1.
Table 8-3 White Balance Status Description
White Balance
Mode
Parameter
Parameter Value
Description
Off
Image Setting >
Balance White
Auto
Off
You need to set the R, G, B value
manually, between 1 and 4095.
1024 means ratio is 1.0
Once
Image Setting >
Balance White
Auto
Once
Automatic white balance once.
Adjust the white balance for a
certain amount of time then stop. It
implements an algorithm that finds
possible gray areas in the Bayer
data.
Continuous
Image Setting >
Balance White
Auto
Continuous
Continuous automatic white
balance. It implements an
algorithm that finds possible gray
areas in the Bayer data.
You can set white balance as shown below.
Steps:
1. Click Image Setting > Balance White Auto and Balance Ratio Selector.
2. Set Balance White Auto and corresponding Balance Ratio Selector according to actual
demands.
Figure 8-18 Set Balance White