HikRobot X86 - 8.3 Pixel Format Selection; 8.4 Exposure Mode Configuration

X86 Open Platform·User Manual
33
Image Offset X refers to the horizontal coordinate of the upper left corner of the ROI, and Image
Offset Y refers to the vertical coordinate of the upper left corner of the ROI.
8.3 Set Pixel Format
The mono device supports Mono 8 format only, and color device supports Mono 8, Bayer 8, and
RGB 8 format. You can set pixel format as shown below.
Steps:
1. Click Image Setting > Pixel Format.
2. Set Pixel Format according to actual demands.
Figure 8-3 Set Pixel Format
8.4 Set Exposure Mode
The X86 open platform supports exposure function. For specific exposure range that the device
supports, please refer to the specifications of the device.
The device has 3 types of exposure: Off, Once and Continuous. The exposure mode and principle
are shown below.
Table 8-1 Exposure Mode and Principle
Exposure
Mode
Parameter
Parameter Value
Principle
Off
Image Setting >
Exposure Auto
Off
The device exposures
according to the value
configured by user in
Exposure Time(µs).