HikRobot X86 - 5.4.4 Trigger Debouncer Setup

X86 Open Platform·User Manual
24
When triggering via High Level or Low Level, you can also set Start Delay Time(μs) and End Delay
Time(μs), as shown below.
Figure 5-8 Set Start and End Delay Time
5.4.4 Set Trigger Debouncer
The external trigger input signal of the device may have signal bounce that may cause false trigger.
Thus, it is necessary to debounce the external trigger signal, and its sequence diagram is shown
below.
Trigger_in1 Trigger_in2 Trigger_in3
Trigger_in2 Trigger_in3
Before
debounce
After
debounce
Debouncer Time Debouncer Time
Figure 5-9 Trigger Debouncer Sequence Diagram
You can set trigger debouncer as shown below.
Steps:
1. Click Trigger and IO Control > Debouce Time(μs).
2. Enter proper value in Debouce Time(μs) according to actual demands.