X86 Open Platform·User Manual
12
Chapter 3 Client Installation and Setting
3.1 Install MVS Client
The MVS client software for X86 open platform is compatible with 32/64-bit Windows XP/7/10
operating systems.
Software version in this manual is V3.1.0. If other versions are used, the graphic user interface
may differ.
You can download the client software installation package from en.hikrobotics.com.
Steps:
1. Double click MVS installation package to install the client.
Figure 3-1 Installation Interface
2. Read the Terms of the License Agreement and check it.
3. Click Start Setup.
3.2 Set Network Interface Card
Steps:
1. After installing MVS client, click Start Menu of the PC to find NIC_Configurator.
2. Click NIC_Configurator to run it.
To Next Page
Loading...
