HIKVISION AX DS-PWA32-HSR - Alarm Reporting Issues Troubleshooting; Function Exclusion Troubleshooting

Soluon:
Check whether the detector reports undervoltage. Replace the detector baery
A.3.2 Zone Tamper-proof
Fault Descripon:
View status of zones which displays tamper-proof.
Soluon:
Make tamper-proof buon of the detector holden.
A.3.3 Zone Triggered/Fault
Fault Descripon:
View status of zones which displays triggered/fault.
Soluon:
Reset the detector.
A.4 Problems While Arming
A.4.1 Failure in Arming (When the Arming Process is Not Started)
Fault Descripon:
When the panel is arming, prompt arming fails.
Soluon:
The panel does not enable "forced arming", and when there is a fault in the zone, the arming will
fail. Please turn on the "forced arming" enable, or restore the zone to the normal status.
A.5
Operaonal Failure
A.5.1 Failed to Enter the Test Mode
Fault Descripon:
Failed to enable test mode, prompng "A fault in the zone".
Soluon:
Zone status, alarm status or zone power is abnormal.
AX Security Control Panel
95