HIKVISION AX DS-PWA32-HSR

3. Customize a name for the card in the pop-up window.
4. Select the card type and card linked
paron.
5. Select the permission for the card.
Note
You should allocate at least a permission for the card.
6. Click OK and the tag
informaon will be displayed in the list.
Note
The card supports at least 20-thousand serial numbers.
7. Oponal: Click and you can change the card name.
8.
Oponal: Delete a single card or check mulple cards and click Delete to delete cards in batch.
4.3.6 Maintenance
Test
The security control panel supports walk test funcon.
Steps
1. Enter Maintenance → Test → to enable the
funcon.
Note
Only when all the detectors are without fault, you can enter the mode TEST mode.
2. Check the Test check box to start walk test.
3. Click Save to complete the
sengs.
4. Trigger the detector in each zone.
5. Check the test result.
AX Security Control Panel
50