HIKVISION DS-1100KI(B) - Chapter 3 Network

Chapter 3 Network
Network parameters must be properly congured before you can add network devices and operate
the network keyboard over network.
Steps
1. Go to System → Network .
2.
Congure network parameters.
-
Enable DHCP to obtain IP sengs automacally.
-
Manually enter IP address, subnet mask, and gateway.
-
Enable SADP to search devices, change IP addresses through SADP
soware.
3. Tap Save.
Figure 3-1 Network Parameters
DS-1100KI(B) Network Keyboard User Manual
4