HIKVISION DS-1100KI(B) - Serial Port Settings; Network

5. Click Edit in Camera Group interface, uncheck input channels to be unlinked and click OK to
unlink the input channel.
8.4 Serial Port Sengs
RS-485 and RS-232 serial port parameters can be set in the Serial Port Sengs interface. You can
set baud rate, data bit, protocol type, stop bit, parity and other parameters of RS232 and RS485,
edit the address of RS485 serial port, and copy RS485 serial port
sengs to all.
• Congure the parameters of RS-485 port when the serial port is connected to analog dome.
•
Congure the parameters of RS-232 port when the serial port is connected to the analog matrix.
Figure 8-8 RS485 Serial Port Sengs
Figure 8-9 RS232 Serial Port Sengs
8.5 Network
Steps
1. Select Network Management at the main interface.
2. Congure network parameters.
DS-1100KI(B) Network Keyboard User Manual
53