HIKVISION DS-1100KI(B) - Page 26

3. Press Num+PATROL to select which patrol to set.
Preset
It determines the order at which the PTZ will follow while moving through the patrol.
Speed
It denes the speed at which the PTZ will move from one preset to the next.
Duraon
It refers to the me span to stay at the preset.
Figure 4-8 Edit Patrol
4. Press Num+ENTER to select preset.
5. Press Num+ENTER to set
duraon.
6. Press Num+ENTER to set speed.
Note
If you press Num+PATROL during steps 4 to 6, the sengs will be cleared.
7. Repeat steps 4 to 6 to set more points of the patrol.
8. Press SET to
nish seng.
Note
Press Num+PATROL again to clear all parameters set. Press SET to reset.
9. Press Num+PATROL to call the patrol.
Note
You can also tap in Local Live View interface to select Patrol, set and call patrol.
DS-1100KI(B) Network Keyboard User Manual
13