Control Panel User Manual
51
{1} The programming command addressof zone configuration is
531～538.
{2} The configuration item of 3 indicates zone configuration of the
partition.
{3} Add/Delete Zone.
{4} Zone No.
{5} End the command.
There are three mode to add/delete zone for the partition,
adding/deleting separately, Adding/ Deleting continually and
adding/deleting in Batch, for details, refer to the Partition Keypad User
Configuration.
Partition Keypad Configuration
The programming command of keypad configuration of the partition is shown
as follows.
{1} The programming command address of zone configuration is 531～
To Next Page
Loading...
