HIKVISION DS-3 Series - Network Status

Congure the rate and duplex mode of a port. The default value is Auto/Auto. You can select
dierent combinaons of rates and duplex modes as required.
Flow Control
Enable or disable ow control of a port. By default, ow control is enabled. Enabling ow
control can eecvely reduce the impact of large amounts of data on the network and maintain
the stability of the network.
PoE Power
You can view the whole device PoE power and peak PoE power in last seven days of the switch.
Click in the upper right corner of the module to go to the PoE Management page for PoE
funcon conguraon.
Figure 3-9 View PoE Power
Note
PoE power display is only available for switches supporng PoE.
3.3 Network Status
Network Monitoring allows you to view the same-LAN network device informaon, MAC
addresses learned by ports, port
stascs, and cable status.
Find Network Devices
Network Device Discovery is a funcon that automacally detects transmission devices in the
same LAN with the switch and displays informaon about these devices. Go to Network
Monitoring → Network Device Discovery , and you can view the device IP address, type, model,
and serial No. of the network device(s) found. You can also select a device and click
in the
Operaon column to go to the web conguraon page of the device.
Figure 3-10 Find Network Devices
Smart Managed Switch Web User Manual
10