HIKVISION DS-3 Series - Configure Port VLAN

Note
●
The VLAN ID should be an integer between 1 and the maximum number of VLANs allowed
by the device. For example, if the maximum number of VLANs allowed is 4094, the VLAN ID
should be integer between 1 and 4094.
●
The end VLAN ID should be greater than the start VLAN ID.
●
The number of VLANs to be batch added should be no more than the maximum number of
VLANs that can be added in a batch. For example, in the case that the maximum number of
VLANs that can be added in a batch is 128, if you set the start VLAN ID to 1, the end ID
cannot be greater than 128.
6.
Click Save.
7.
Oponal: Select the desired VLAN(s) and click Delete to delete one or more VLANs.
Note
The default VLAN 1 cannot be deleted.
4.3.2 Congure Port VLAN
Steps
1.
Select the desired port(s) on the port panel.
Note
●
You can also click or on the right to batch select or deselect all ports.
●
VLAN conguraon is not allowed for ports in an aggregaon group.
2.
Congure the port VLAN type.
Figure 4-9 Congure Port VLAN
-
ACCESS: An ACCESS port can have only one VLAN congured on the interface, and it can carry
trac for only one VLAN, usually the default VLAN (VLAN 1). Select Type as ACCESS, and set
PVID.
-
TRUNK: A TRUNK port can have two or more VLANs congured on the interface, and it can
carry
trac for several VLANs simultaneously. Select Type as TRUNK, set PVID, and enter
Accessible VLANs.
Smart Managed Switch Web User Manual
20