HIKVISION DS-3 Series - Configure Link Aggregation

4.1.2 Congure Link Aggregaon
Link aggregaon is used to combine mulple physical links together to make a logical high-
bandwidth data path, which provides a stronger and faster network
connecon.
Steps
1.
Go to L2 Conguraon → Link Aggregaon .
2.
Click .
Figure 4-2 Congure Link Aggregaon
3.
Select at least two desired ports.
Note
●
Only the selectable ports can be added to an aggregaon group.
●
2 to 4 ports are allowed for each link aggregaon group.
●
Some ports can only be added to a specic aggregaon group. Please refer to the actual
situaon.
●
The rate, duplex mode,
ow control, long-range mode, and VLAN conguraons of ports in
one
aggregaon group should be the same.
4.
Set Aggregaon Group Number.
Note
The number of aggregaon groups allowed varies.
5.
Click Save.
6.
Oponal: Edit the aggregaon group.
1) Click an
exisng aggregaon group, for example, "Aggregaon Group 1".
2) Select the desired port(s) on the le port panel to add to the group, or deselect the desired
port(s) on the right to delete from the group.
3) Click Edit to save the
modicaon.
7.
Oponal: Delete the aggregaon group.
1) Click an
exisng aggregaon group, for example, "Aggregaon Group 1".
2) Click Delete on the right.
8.
Oponal: View the member ports of each aggregaon group in the list below.
Smart Managed Switch Web User Manual
14