HIKVISION DS-3 Series - View Port Statistics

Query Port MAC Address
You can query the MAC address(es) learned by each port. Go to Network Monitoring → MAC
Address , select the desired port from the Port drop-down list, and click Search. The MAC
address(es) learned by the port and type(s) of the MAC address(es) are displayed in the list below.
Figure 3-11 Query Port MAC Addresses
View Port Stascs
You can monitor and collect stascs on the transmied data of device ports. Go to Network
Monitoring → Port Stascs , and you can view the current connecon status of each port and the
data transmied by each port in the stascs list.
Figure 3-12 View Port Stascs
You can also perform the following
operaons:
●
Clear port stascs: You can click Clear All to clear all the port stascs.
●
Manually refresh port stascs: You can click to manually refresh the port stascs.
●
Auto refresh port stascs: You can set the interval for automacally refreshing port stascs:
30 seconds or 60 seconds.
Detect Cable Status
Cable Detecon is a funcon that detects the statuses of Ethernet port cables, for example, to
check whether there is a short circuit or an open circuit in the receiving or sending direcon of a
cable, and if any, to locate the faulty cable. Go to Network Monitoring → Cable
Detecon , select
the desired port on the le port panel, and click Detect to view the detecon result.
Smart Managed Switch Web User Manual
11