HIKVISION DS-3 Series - Configure Long-Range Mode; Configure High-Priority Port

4.1.5 Congure Long-Range Mode
Aer the long-range mode is enabled for a port, the transmission distance of the port can reach
300 meters at a rate of 10 Mbps.
Steps
1.
Go to L2
Conguraon → Long-Range Mode .
Figure 4-5 Congure Long-Range Mode
2.
Select the desired port(s) on the port panel.
Note
You can also click or on the right to batch select or deselect all ports.
3.
Enable or disable Long-Range Mode as required.
4.
Click Save.
5.
Oponal: View the long-range status of each port in the Port Long-Range Status list.
4.1.6
Congure High-Priority Port
High-priority ports are idened by a red area on the device front panel. In the case of uplink
congeson, the data of ports in this area is preferenally transmied.
Steps
1.
Go to Service Quality → High-Priority .
Note
High-priority port conguraon is only supported when the switch has high-priority ports.
Smart Managed Switch Web User Manual
17