HIKVISION DS-3 Series - Chapter 4 Device Configuration; Port Configuration; Configure Port Attributes

Chapter 4 Device Conguraon
4.1 Port Conguraon
4.1.1 Congure Port Aributes
The basic aributes can inuence the working status of a port. Set the parameters as required.
Steps
1.
Go to L2 Conguraon → Port Aributes .
Figure 4-1 Congure Port Aributes
2.
Select the desired port(s) and congure the parameters.
Port Up
Enable or disable the selected port(s). If a port is enabled, it is in the up state; if a port is
disabled, it is in the down state. No data will be
transmied on a "down" port.
Duplex Mode
The duplex mode of a port. The congurable duplex modes of ports include Half-Duplex, Full-
Duplex, and Auto, which may vary with device models.
Rate (Mbps)
The data transmission speed of a port of a port. The
congurable rates of ports include 10M,
100M, 1000M, and Auto, which may vary with device models.
Flow Control
Enable or disable ow control of a port. Enabling ow control can prevent data loss in data
transmission.
3.
Click Save.
4.
Oponal: View the port aributes in the port status list.
Smart Managed Switch Web User Manual
13