HIKVISION DS-3 Series - Time Synchronization

Note
If Redirect HTTP to HTTPS is enabled, trac accessed through port 80 will be automacally
redirected to port 443.
●
SSH: SSH is used for fault locang by technical support, and is not available to users.
5.2 Time Synchronizaon
Steps
1.
Go to System Management → Time Conguraon .
2.
Set Time Zone.
3.
Set Time Sync Mode.
-
Manually: Manually set the date and me, or check Sync with Computer Time to synchronize
the system date and
me.
Figure 5-5 Congure Time Manually
-
With NTP Server: Enter the NTP server address, port number, and me sync interval for
automac me synchronizaon.
Figure 5-6 Congure Time with NTP Server
-
With Hik-Connect Server: Use the Hik-Connect server for automac me calibraon and
synchronizaon. You do not need to congure any parameters.
Smart Managed Switch Web User Manual
27