HIKVISION DS-3 Series - Page 8

Note
●
You can obtain the default IP address of the switch using the SADP tool.
●
You are recommended to use the following web browsers: Microso Edge 89 or later, Google
Chrome 89 or later, and Firefox 78 or later.
2.
Set a password and conrm the password.
Note
●
The password should contain 8 to 16 characters, including at least two types of the following
categories: uppercase leers, lowercase leers, digits, and special characters.
●
The password cannot contain user name, '123', or 'admin' (case-insensive), 4 or more
consecuvely increasing or decreasing digits (such as '1234' and '4321'), or 4 or more idencal
characters (such as '1111' and 'aaaa').
●
The password cannot be a common risky password.
3.
Oponal: Check Cloud Management.
The Hik-Connect service is enabled.
4.
Click OK.
The network conguraon page is displayed.
5.
Oponal: Modify the network conguraons.
1) Go to System Management → Network Conguraon → Network Conguraon .
Figure 2-2 Modify Network Parameters
Smart Managed Switch Web User Manual
3