HIKVISION DS-7600NI-E1/A - Adding the Online IP Cameras

User Manual of All-in-One Network Video Recorder
33
3. Set the password of the camera to activate it.
Use Admin Password: when you check the checkbox, the camera (s) will be configured with the same
admin password of the operating NVR.
Figure 2. 22 Set New Password
Create New Password: If the admin password is not used, you must create the new password for the camera
and confirm it.
STRONG PASSWORD RECOMMENDED– We highly recommend you create a strong
password of your own choosing (using a minimum of 8 characters, including upper case letters,
lower case letters, numbers, and special characters) in order to increase the security of your
product. And we recommend you reset your password regularly, especially in the high security
system, resetting the password monthly or weekly can better protect your product.
4. Click OK to finish the acitavting of the IP camera. And the security status of camera will be changed to
Active.
2.6.1 Adding the Online IP Cameras
Purpose:
The main function of the NVR is to connect the network cameras and record the video got from it. So before you
can get a live view or record of the video, you should add the network cameras to the connection list of the device.
 Auto Scan to Add
Purpose:
Once the Auto Scan to Add function is enabled, the NVR will automatically add the IP cameras in the same
segment network. And by default, the function is enabled.
Steps:
1. Enter IP Camera Management interface.
 Option 1: Right-click in the live view mode and click Add IP Camera.