HIKVISION DS-7608NXI-K2

2.
In the Added Device List, click Add and set the parameters of the device.
Table 5-2 Device Parameter Descripon
Parameter Descripon
IP Address The IP address of the IP speaker.
Management Port It is recommended to keep the default conguraon.
User Name / Password The user name / password of the IP speaker.
Use Camera Acvaon
Password
Use the camera acvaon password of the video recorder to add
the IP speaker.
3.
Click Add and Connue and repeat operaon unl all devices have been added.
Note
Up to 4 IP speakers can be added.
4.
Click Add.
Link IP Speaker to Channel
IP speakers can be linked to camera to realize sound alarm linkage and two-way audio.
Steps
1.
Go to Conguraon → Device Access → IP Speaker .
2.
In the Added Device List, select a device and click
.
3.
Select the channel(s) to link.
4.
Click OK.
Batch Time Sync
Supports batch me sync of the IP speakers.
Steps
1.
Go to Conguraon → Device Access → IP Speaker .
2.
In the Added Device List, click Batch Time Sync.
3.
Turn on Enable Time Sync.
4.
Set Time Sync Interval.
5.
Click OK.
Congure
Audio Parameters
Steps
1.
Go to Conguraon → Device Access → IP Speaker .
Network Video Recorder User Manual
32