HIKVISION DS-7608NXI-K2

4.
Click Apply.
6.2.5 Upload Logs to the Server
You can upload system logs to the server for backup.
Steps
1.
Go to Conguraon → Network → General → Log Server Sengs .
Figure 6-5 Log Server Sengs
2.
Turn on Enable
3.
Set Upload Time Interval, Server IP Address, and Port.
4.
Oponal: Click Test to test if parameters are valid.
5.
Click Apply.
6.2.6 Ports (More
Sengs)
Set dierent port types to enable relevant funcons as your desire.
Go to
Conguraon → Network → General → More Sengs .
Alarm Host IP/Port
The device will send the alarm event or excepon message to the alarm host when an alarm is
triggered. The remote alarm host must have the client management system (CMS)
soware
installed.
Alarm Host IP refers to the IP address of the remote PC on which the CMS soware (e.g.,
iVMS-4200) is installed, and the Alarm Host Port (7200 by default) must be the same as the
alarm monitoring port
congured in the soware.
Server Port
For remote client soware access. Ranges from 2000 to 65535. The default value is 8000.
HTTP Port
Network Video Recorder User Manual
46