HIKVISION DS-K1A802A Series - Chapter 8 Remote Configuration Via Client Software; Check Device Information; Edit Device Name; Edit Time

Chapter 8 Remote Conguraon via Client Soware
Congure device parameters remotely.
8.1 Check Device Informaon
Steps
1.
Click Maintenance and Management → Device to enter the device list.
2.
Press CTRL and click to enter the remote conguraon page.
3.
Click System → Device Informaon and view the device basic informaon and the device
version informaon.
8.2 Edit Device Name
Click Maintenance and Management → Device to enter the device list.
Press CTRL and click
to enter the remote conguraon page.
Click System → General to congure the device name and overwrite record les parameter.
Click Save.
8.3 Edit Time
Steps
1.
Click Maintenance and Management → Device to enter the device list.
2.
Press CTRL and click
to enter the remote conguraon page.
3.
Click System → Time to congure the me zone.
4.
Oponal: Check Enable NTP and set the NTP server address, the NTP port, and the
synchronizaon interval.
5.
Oponal: Check Enable DST and set the DST start me, end me and the bias.
6.
Click Save.
8.4 Set System Maintenance
You can reboot the device remotely, restore the device to default sengs, import conguraon
le, upgrade the device, etc.
Steps
1.
Click Maintenance and Management → Device to enter the device list.
2.
Click
to enter the remote conguraon page.
3.
Click System → System Maintenance .
DS-K1A802A Series Fingerprint Time Aendance Terminal User Manual
109