HIKVISION DS-K1A802A Series

9.
Click Save.
The aendance status will be valid within the congured me duraon.
Result
Enter the device inial page, the current aendance mode will be displayed on the page. If you do
not select a status, the
authencaon will be marked as the congured aendance status
according to the congured me. If you press the key on the keypad, and select a status to take
aendance, the authencaon will be marked as the selected aendance status.
Example
If set the Up key as check in and the Down key as check out, and set the check in's
me as Monday
08:00, and check out's me as Monday 17:00, the valid person's authencaon before 17:00 on
Monday will be marked as check in. And the valid person's
authencaon aer 17:00 on Monday
will be marked as check out.
6.6
Congure Linkage Acons for Access Control
You can congure dierent linkage acons for the event detected by the access control device.
Aer that, linkage acons will be triggered once the event happens. This mechanism is used for
nofying the security personnel the event, or triggering automac access control in real me.
Two types of linkage acons are supported:
●
Client
Acons: When the event is detected, it will trigger the acons on the client, such as the
client making an audible warning..
●
Device
Acons: When the event is detected, it will trigger the acons of a specic device, such
as buzzing of a card reader and, opening/closing of a door, ..
6.6.1
Congure Client Acons for Access Event
Even if you are far away from an access point, you can sll know what happens and how urgent the
event is by conguring linked acons of access event on the client. You will be noed on the client
once an event is triggered, so that you can response to the event instantly. You can also
congure
client acons of access points in a batch at a me.
Steps
Note
The linkage acons here refer to the linkage of the client soware's own acons such as audible
warning, email linkage, etc.
1.
Click Event Management → Access Control Event .
The added access control devices will display in the device list.
2.
Select a resource (including device, alarm input, door/elevator, and card reader) from the device
list.
DS-K1A802A Series Fingerprint Time Aendance Terminal User Manual
75