HIKVISION DS-K1A802A Series User Manual

Enter the account name registered on EHome protocol.
EHome Key
Enter the EHome key if you have set it when conguring network center parameter for the
device.
Note
This funcon should be supported by the device.
6.
Oponal: Check Synchronize Time to synchronize the device me with the PC running the client
aer adding the device to the client.
7.
Oponal: Check Import to Group to create a group by the device name.
8.
Finish adding the device.
-
Click Add to add the device and back to the device list page.
-
Click Add and New to save the sengs and connue to add other device.
9.
Oponal: Click on Operaon column to view device status.
6.1.5 Import Devices in a Batch
The devices can be added to the soware in a batch by entering the device informaon in the pre-
dened CSV le.
Steps
1.
Enter the Device Management page
2.
Click Add to open the adding device window.
3.
Select Batch Import as the adding mode.
4.
Click Export Template and then save the
pre-dened template (CSV le) on your PC.
5.
Open the exported template le and enter the required informaon of the devices to be added
on the corresponding column.
Adding Mode
You can enter 0 or 1 which indicated
dierent adding modes. 0 indicates that the device is
added by IP address or domain name; 1 indicates that the device is added via EHome.
Address
Edit the address of the device. If you set 0 as the adding mode, you should enter the IP
address or domain name of the device; if you set 1 as the adding mode, this
led is not
required.
Port
Enter the device port No. The default value is 8000.
Device Informaon
If you set 0 as the adding mode, this eld is not required. If you set 1 as the adding mode,
enter the EHome account.
User Name
DS-K1A802A Series Fingerprint Time Aendance Terminal User Manual
51

HIKVISION DS-K1A802A Series Specifications

General

Brand	HIKVISION
Model	DS-K1A802A Series
Category	Touch terminals
Language	English