HIKVISION DS-K1A802A Series - Chapter 4 Activation; Activate via Device

Chapter 4 Acvaon
You should acvate the device before the rst login. Aer powering on the device, the system will
switch to Device
Acvaon page.
Acvaon via the device, SADP tool and the client soware are supported.
The default values of the device are as follows:
●
The default IP address: 192.0.0.64
●
The default port No.: 8000
●
The default user name: admin
4.1
Acvate via Device
If the device is not acvated before rst login, the system will enter the Device Acvaon interface
aer powering on.
Steps
1.
Create a device password for
acvaon.
2.
Conrm the password.
Note
Press the up or down key on the keypad to change the input method.
3.
Press OK to acvate the device.
Note
We highly recommend you to create a strong password of your own choosing (using a minimum
of 8 characters, including at least three kinds of following categories: upper case leers, lower
case leers, numbers, and special characters) in order to increase the security of your product.
And we recommend you reset your password regularly, especially in the high security system,
reseng the password monthly or weekly can beer protect your product.
What to do next
Aer the device acvaon, you will enter the administrator adding page. Add an administrator
before other
operaons.
4.2
Acvate via SADP
SADP is a tool to detect, acvate and modify the IP address of the device over the LAN.
DS-K1A802A Series Fingerprint Time Aendance Terminal User Manual
9