HIKVISION DS-K1A802A Series

Note
Make sure the aendance status is enabled. By default, it is enabled.
3.
Press ESC and save the aendance mode.
4.
Move the cursor and select Shortcut Key and
dene the shortcut key's aendance status.
5.
Press ESC and save the
sengs.
Result
Press a key on the keypad to select an aendance status and authencate. The authencaon will
be marked as the congured aendance status according to the dened shortcut key.
Or when you
authencate on the inial page, you will enter the Select Status page. Select a status
to take aendance.
Note
If you do not select a status for about 20 s, the authencaon will be failed and it will not be
marked as a valid aendance.
5.6.3 Set Manual and Auto Aendance
Set the aendance mode as manual and auto and the system will auto change the aendance
status according to the congured parameters. At the same me you can manually change the
aendance status before the authencaon.
Before You Start
Add at least one person, and set the person's authencaon mode. For details, see Person
Management .
Steps
1.
Move the cursor and select System → A. Status to enter the Aendance Status page.
2.
Move the cursor and select Aendance Mode and set the aendance mode as Manual and
Auto.
DS-K1A802A Series Fingerprint Time Aendance Terminal User Manual
24