HIKVISION DS-K1A802A Series

5.4.3 Set EHome Parameters
Set EHome parameters and the device can upload data via EHome protocol.
Before You Start
Make sure your device has connect to a network.
Steps
1.
Move the cursor and select Comm. → EHome .
Figure 5-3 EHome Sengs
2.
Enable the EHome funcon and set the EHome server parameters.
Center Group 1
Enable center group 1 and the data will be uploaded to the center group.
EHome
Enable EHome funcon and the data will be uploaded via EHome protocol.
Address Type
Select an address type according to your actual needs.
IP Address
Set the EHome server's IP address.
DS-K1A802A Series Fingerprint Time Aendance Terminal User Manual
17