HIKVISION DS-K1A802A Series

7.
Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and connue to add other persons .
Note
Once the ngerprint is added, the ngerprint type cannot be changed.
6.2.6 Congure Access Control Informaon
When adding a person, you can set her/his access control properes, such as seng the person as
visitor or as blocklist person, or as super user who has super
authorizaon.
Steps
1.
Enter Person module.
2.
Select an
organizaon in the organizaon list to add the person and click Add.
Note
Enter the person's basic informaon rst. For details about conguring person's basic
informaon, refer to Congure Basic Informaon .
3.
In the Access Control panel, set the person's access control properes.
PIN Code
The PIN code must be used aer card or ngerprint when accessing. It cannot be used
independently. It should contain 4 to 8 digits.
Device Operator
For person with device operator role, he/she is authorized to operate on the access control
devices.
Note
The Super User, Extended Door Open Time, Add to Blocklist, and Mark as Visitor funcons
cannot be enabled concurrently. For example, if one person is set as super user, you cannot
enable extended door open me for her/him, add her/him to the blocklist, or set her/him as
visitor.
4.
Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and
connue to add other persons.
6.2.7 Customize Person
Informaon
You can customize the person properes which are not pre-dened in the client according to actual
needs, e.g., place of birth. Aer customizing, when add a person, you can enter the custom
informaon to make the person informaon complete.
DS-K1A802A Series Fingerprint Time Aendance Terminal User Manual
56