HIKVISION DS-K1A802A Series

3) Click anywhere on the page to conrm the sengs. The congured me will be displayed in
white.
7.
Set shortcut key from the drop-down list for the aendance status.
8.
Click Save.
The aendance status will be valid within the congured me duraon.
Result
Enter the device inial page, the current aendance mode will be displayed on the page. When
you
authencate on the inial page, the authencaon will be marked as the congured
aendance status according to the congured me.
Example
If set the Up key as check in and the Down key as check out, and set the check in's schedule as
Monday 08:00, and check out's schedule as Monday 17:00, the valid person's
authencaon
before 17:00 on Monday will be marked as check in. And the valid person's authencaon aer
17:00 on Monday will be marked as check out.
Set Manual and Auto
Aendance
Set the aendance mode as manual and auto and the device system will auto change the
aendance status according to the congured parameters. At the same me you can manually
change the aendance status before the authencaon.
Before You Start
Add at least one person, and set the person's
authencaon mode. For details, see Person
Management .
Steps
1.
Click Access Control → Advanced Funcon → More Parameters to enter the More Parameters
page.
2.
Select a device from the
le panel.
3.
Click Aendance Status.
4.
Set the
aendance mode as Manual and Auto.
5.
Make sure Aendance Status Required is enabled.
Note
By default, Aendance Status Required is enabled.
6.
Set status lasts me.
7.
Set available me for the target aendance status.
1) Move the cursor on the target me and the enable checkbox will display.
2) Check the checkbox and set the available
me.
3) Click anywhere on the page to conrm the sengs. The congured me will be displayed in
white.
8.
Set shortcut key from the drop-down list for the
aendance status.
DS-K1A802A Series Fingerprint Time Aendance Terminal User Manual
74