Steps
Note
●
The device should be installed concrete surface or other at
non-ammable surface.
●
If the installaon area is too close to the wall, make sure the
distance between the pedestal and the wall should be no less
than 20 mm (40 mm if with face
recognion terminals), or you
cannot open the pedestal's top panel or might cause damage
to devices.
●
The dimension is as follows.
Figure 2-1 Dimension
1. Draw a central line on the installaon surface of the le or
right pedestal.
2. Draw other parallel lines for installing the other pedestals.
Note
The distance between the nearest two line is L + 180 mm. L
represents the lane width.
3. Slot on the installaon surface and dig installaon holes. Put 3
expansion bolts of M12*150 for each pedestal.
2
To Next Page
Loading...