HIKVISION DS-K3BC430LX-868 - Set Door Parameters; Serial Port Settings

Enable to report alarm when the card reading aempts reach
the set value.
Max. Authencaon Failed Aempts
Enable to report alarm when the card reading aempts reach
the set value.
Communicaon with Controller Every
When the access control device cannot connect with the card
reader for longer than the set me, the card reader will turn
oine automacally.
Note
The authencaon interval value ranges from 2 s to 255 s.
Set Door Parameters
Click Conguraon → Access Control → Door Parameters .
Figure 7-9 Door Parameters Sengs Page
Click Save to save the sengs aer the conguraon.
Door No.
Select Entrance or Exit for sengs.
Door Name
You can create a name for the door.
Open Duraon
Set the door unlocking duraon. If the door is not opened for
the set me, the door will be locked.
Note
The open duraon ranges from 5 s to 60 s.
Exit Buon Type
You can set the exit buon as Remain Open or Remain Closed
according to your actual needs. By default, it is Remain Open.
Door Remain Open
Duraon with First Person
Set the door open duraon when rst person is in. Aer the
rst person is authorized, it allows mulple persons access the
door or other authencaon acons.
Note
The duraon ranges from 1 s to 1440 s.
Serial Port Sengs
Set serial port parameters.
Steps
1. Click Conguraon → Access Control → Serial Port Sengs .
28