HIKVISION DS-K3BC430LX-868 - 6.2 Administrator Settings; 7 Operation via Web Browser; 7.1 Login

Click in the top right of the web page to enter the wizard page.
Aer seng device language, you can click Next to enter the
Time Sengs page.
Time Zone
Select the device located me zone from the drop-down list.
Time Sync.
NTP
You should set the NTP server's IP address, port No., and
interval.
Manual
By default, the device
me should be synchronized
manually. You can set the device
me manually or check
Sync. with Computer Time to synchronize the device me
with the computer's me.
DST
Enable DST. Set the DST start me, end me and bias me.
Click Next to save the sengs and go to the next parameter. Or
click Skip to skip
me sengs.
6.2 Administrator Sengs
Steps
1.
Click in the top right of the web page to enter the wizard
page. Aer seng me, you can click Next to enter the
Administrator Sengs page. Or you can click Skip to enter the
Administrator
Sengs page directly.
2. Enter the employee ID and name of the administrator.
3. Select a credenal to add.
Note
You should select at least one credenal.
1) Click Add Card to enter the Card No. and select the property
of the card.
Note
Up to 50 cards can be supported.
4. Click Complete to complete the sengs.
7
Operaon via Web Browser
7.1 Login
You can login via the web browser or the remote conguraon of
the client
soware.
Note
Make sure the device is acvated. For detailed informaon about
acvaon, see Acvaon.
Login via Web Browser
20