HIKVISION DS-K3BC430LX-868 - 7.5.11 Card Settings; Set Card Security

2. Set Alarm Output Duraon.
Note
The alarm output duraon ranges from 0 s to 3599 s.
3. Set Temperature Unit.
4. Drag the block or enter the value to adjust the light board
brightness.
5. Set the alarm buzzer beeping
duraon, door closing delay me.
6. Choose the control mode.
So Mode
The barrier will be closed aer the person has passed
through the barrier.
Guard Mode
The barrier will be closed immediately.
7. Set the
re input type.
8. Click to enable Motor Self-Test and choose the main lane or
sub lane to start motor self-tesng.
9. Click Save.
10. Click More to adjust Barrier Open Angle.
7.5.11 Card
Sengs
Set Card Security
Click Conguraon → Card Sengs → Card Type to enter the
sengs page.
Set the parameters and click Save.
Enable NFC Card
Reserved.
Enable M1 Card
Enable M1 card and authencang by presenng M1 card is
available.
M1 Card
Encrypon
Sector
M1 card encrypon can improve the security level of
authencaon.
Enable the funcon and set the encrypon sector. By default,
Sector 13 is encrypted. It is recommended to encrypt sector
13.
32