HIKVISION DS-K3BC430LX-868 - Set Wiegand Parameters; Enable M1 Card Encryption

5. Set the baud rate, data bit, the stop bit, parity type, and
connecon mode in the drop-down list.
6. Click Save.
●
The congured parameters will be applied to the device
automacally.
●
When you change the connecon mode, the device will
reboot automacally.
Set Wiegand Parameters
You can set the access control device's Wiegand channel and the
communicaon mode. Aer seng the Wiegand parameters, the
device can connect to Wiegand card reader via Wiegand
communicaon.
Before You Start
Add access control device to the client, and make sure the device
supports Wiegand.
Steps
1. Enter the Access Control module.
2. On the
navigaon bar on the le, enter Advanced Funcon →
More Parameters .
3. Select an access control device in the device list and click
Wiegand to enter the Wiegand
Sengs page.
4. Set the switch to on to enable the Wiegand funcon for the
device.
5. Select the Wiegand channel No. and the communicaon mode
from the drop-down list.
Note
If you set Communicaon Direcon as Sending, you are
required to set the Wiegand Mode as Wiegand 26 or Wiegand
34.
6. Click Save.
●
The congured parameters will be applied to the device
automacally.
●
Aer changing the communicaon direcon, the device will
reboot
automacally.
Enable M1 Card Encrypon
M1 card encrypon can improve the security level of
authencaon.
Steps
Note
The funcon should be supported by the access control device
and the card reader.
1. Enter the Access Control module.
2. On the navigaon bar on the le, enter Advanced Funcon →
More Parameters .
3. Select an access control device in the device list and click M1
Card
Encrypon to enter the M1 Card Encrypon page.
4. Set the switch to on to enable the M1 card encrypon
funcon.
5. Set the sector ID.
55