HIKVISION DS-K3BC430LX-868 - 7.5.2 Set Time; 7.5.3 Set DST; 7.5.4 Change Administrators Password

Click Conguraon → System → System Sengs → Basic
Informaon to enter the conguraon page.
You can view the device name, language, model, serial No.,
version, IO input, IO output, and local RS-485 number.
You can change Device Name and click Save.
You can view the device capacity, including person, card and
event.
7.5.2 Set Time
Set the device's me zone, synchronizaon mode, server address,
NTP port, and interval.
Click Conguraon → System → System Sengs → Time
Sengs .
Figure 7-4 Time Sengs
Click
Save to save the
sengs aer the conguraon.
Time Zone
Select the device located me zone from the drop-down list.
Time Sync.
Manual
By default, the device
me should be synchronized
manually. You can set the device
me manually or check
Sync. with Computer Time to synchronize the device me
with the computer's me.
Server IP Address/NTP Port/Interval
You can set the server IP address, NTP port, and interval.
7.5.3 Set DST
Steps
1. Click
Conguraon → System → System Sengs → Time
Sengs .
2. Enable DST.
3. Set the DST start me, end me and bias me.
4. Click Save to save the sengs.
7.5.4 Change Administrator's Password
Steps
1. Click
Conguraon → User Management .
2.
Click .
3. Enter the old password and create a new password.
4. Conrm the new password.
5. Click OK.
24