You can enable Verify Credenal Locally. Aer enabling the funcon, the device will only
verify the person's permission without the schedule template, etc.
Access Control Mode
The device works normally and will verify the person's permission to open the barrier.
3.
Set remote vericaon.
1) Enable Remote Vericaon.
Note
The device will upload the person's authencaon informaon to the plaorm. The plaorm
will judge to open the barrier or not.
2) Oponal: Enable Verify Credenal Locally.
Note
Aer enabling the funcon, the device will only verify the person's permission without the
schedule template, etc.
4.
Click Save to complete terminal parameter sengs.
7.5.10
Turnsle
Basic Parameters
Set turnsle basic parameters.
Steps
1.
Click Conguraon → Turnsle → Basic Sengs to enter the page.
2.
View the Device Type, Device Model and Working Status.
3.
Set Barrier Material, Lane Width, Barrier Height, Barrier Opening Speed and Barrier Closing
Speed.
4.
Set the passing mode.
-
If you choose General Passing, you can select the barrier status for the entrance and exit from
the drop-down list.
Note
If you set barrier-free mode, the barrier remains open and will close when authencaon
fails.
-
If you choose Weekly Schedule, you can set a weekly schedule for entrance and exit barriers.
5.
Click Save.
keyfob
Set keyfob patameters.
DS-K3BC430LX Series Swing Gate
43