HIKVISION DS-K3G501X Series User Manual

Figure 6-6 Event Linkage
2.
Set event source.
-
If you choose Linkage Type as Event Linkage, you need to select event types from the drop-
down list.
-
If you choose Linkage Type as Card Linkage, you need to enter the card No. and select the
card reader.
-
If you choose Linkage Type as Link Employee ID, you need to enter the employee ID and
select the card reader.
3.
Set linkage acon.
Buzzer Linkage
Enable Buzzer Linkage and select Start Buzzing or Stop Buzzing for the target event.
Door Linkage
Enable Linked Door, check Entrance or Exit, and set the door status for the target event.
Linked Alarm Output
Enable Linked Alarm Output, check Alarm Output 1 or Alarm Output 2, and set the alarm
output status for the target event.
Linkage Audio Prompt
Enable Linked Audio Prompt and select the play mode.
●
If you choose TTS, you need to select the play mode, set language and enter the prompt
content.
●
If you choose Audio File, you need to select the play mode, and select an available audio
le from the drop-down list or click General Linkage Sengs to add a new audio le.
DS-K3G501X Series Tripod Turnsle
34

HIKVISION DS-K3G501X Series Specifications

General

Brand	HIKVISION
Model	DS-K3G501X Series
Category	Turnstiles
Language	English